Design and Analysis of PLC Based Industrial Control System
Main Article Content
Abstract
The best quality production and the safety of human beings is the result of moderate and required conditions which are one of the most important industrial parameters. PLC is effective, fast responsive, and has a wide bandwidth. In this paper, we propose a technique of controlling different parameters of the industry through PLC based system by connecting the temperature, pressure, and level sensors with 2A4RTD. In any case of emergency, these sensors will detect the problem and making it easy to control and monitor the situation. 2A4RTD is a combo module that is used for taking analog and resistive inputs from the source, delivering them to the PLC 20-MAR board. PLC accepts the two analoginputs with the help of the 2A4RTD module, which has reduced the additional cost. After getting the information of the input signals,we can get the ranges of temperature, pressure, and oil levels. With the help of ranges, we can estimate the solutions tocontrol their worst levels. Some components like the cooling fan, buzzer,and air conditioner will be connected with the relay or simply connected to the PLC board, to get the issues under control. Data will be collected and monitored through HMI
Article Details
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.
Pakistan Journal Emerging Science and Technologies (PJEST) in collaboration with Govt. Islamia Graduate College Civil Lines Lahore, Pakistan is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.
References
Y.An, F.Qin, B. Chen, R. Simon, and H. Wu, "OntoPLC: Semantic Model of PLC Programs for Code Exchange and Software Reuse," IEEE Transactions on Industrial Informatics, vol. 17, pp. 1702-1711, 2020. https://doi.org/10.1109/TII.2020.2997360
M. Kyoung, C. Yeob, and P. Hyun, "A Novel Monitoring System for the Data Integrity of Reactor Protection System Using Blockchain Technology," Journal of Lightwave Technology, vol. 8, pp. 118732-118740, 2020. https://doi.org/10.1109/ACCESS.2020.3005134
T.Klopot, P.Skupin, P.Grelewicz, and J.Czeczot, "Practical PLC-based Implementation of Adaptive Dynamic Matrix Controller for Energy Efficient Control ofHeat Sources," IEEE Transactions on industrial Electronics vol. 68, pp. 42689-4278, 2020. https://doi.org/10.1109/TIE.2020.2987272
Y. Wei, Y.Wu, X. Zhang, J. Ren, and D. An, "Fuzzy Self-Tuning PID-Based Intelligent Control of an Anti-Wave Buoy Data Acquisition Control System," IEEE Access, vol. 7, pp. 166157-166164, 2019. https://doi.org/10.1109/ACCESS.2019.2947179
M. M. A. M. Elgenedy, R. Hamila, W. U. Bajwa, A. S.Ibrahim, and N.Al-Dhahir, "Sparsity-Based Joint NBI and Impulse Noise Mitigation inHybrid PLC-Wireless Transmissions,"IEEE Access, vol. 6, pp. 30280-30295, 2018. https://doi.org/10.1109/ACCESS.2018.2842194
G. Guo, " Design and implementation of smart campus automatic settlement PLC control system for Internet of Things.,"IEEE Access, vol. 6, pp. 62601-62611, 2018. https://doi.org/10.1109/ACCESS.2018.2877023
Y.Xu, Y.Wu, M.Zhang, and S.Xu, "Sensitivity of Programmable Logic Controllers to Voltage Sags," IEEE Transactionson Power Delivery, vol. 34, pp. 2-10, 2018. https://doi.org/10.1109/TPWRD.2018.2870086
W.Miczulski, M.Krajewski, and S.Sienkowski, "A New Autocalibiration Procedure in Intelligent Temperature Transducer," IEEE Transactions on Instrumentation and Measurement, vol. 68, pp. 895-902, 2018. https://doi.org/10.1109/TIM.2018.2857901
Y.Yamashita, S.Makino, T.Fujisawa, and N.Hanzawa, "PLC-based LP 11 mode rotator with curved trench structure devisedfrom wavefront matching method,"IEEE photonics technology letters, vol. 29, pp. 1063-1066, 2017. https://doi.org/10.1109/LPT.2017.2700496.
J. D. l. Morenas, A.García-Higuera, and P.García-Ansola, "Shop floor control: A physical agents approach for PLC-controlled systems," IEEE Transactions on Industrial Informatics, vol. 13, pp. 2417-2427, 2017. https://doi.org/10.1109/TII.2017.2720696
A.D.Vieira, E.A.Santos, and A.B.Leal, "A Method for PLC Implementation of Supervisory Control of Discrete EventSystems," IEEE Transactions on Control Systems Technology, vol. 25, pp. 175-191, 2017. https://doi.org/10.1109/TCST.2016.2544702
S.Dominic, Y.Löhr, A.Schwung, and S. X.Ding, " PLC-Based Real-Time Realization of Flatness-Based Feedforward Control for Industrial Compression Systems,"IEEE Transactions on Industrial Electronics, vol. 64, pp. 1323-1331, 2016. https://doi.org/10.1109/TIE.2016.2612160
A.Ghosh, S.Qin, J.Lee, and G. N.Wang, "FBMTP: An Automated Fault And Behavioral Anomaly Detection And Isolation Tool For PLC-Controlled Manufacturing Systems,"IEEE Transactions on Systems, Man, and Cybernetics: Systems, vol. 47, pp. 3397-3417, 2016. https://doi.org/10.1109/TSMC.2016.2633392
Y.Yamashita, T.Fujisawa, S.Makino, and N.Hanzasa, "Design and fabrication of broadband PLC-based two-mode multi/demultiplexer using a wavefront matching method.," Journal of Lightwave Technology, vol. 35, pp. 2252-2258, 2016. https://doi.org/10.1109/JLT.2016.2641461
N.Hanzawaet al., "PLC-based four-mode multi/demultiplexer with LP 11 mode rotator on one chip,"Journal of Light wave Technology, vol. 33, pp. 1161-1165, 2015. https://doi.org/10.1109/JLT.2014.2378281
Page 82of 72
A.Cataliotti, V.Cosentino, D. D. Cara, S. Guaiana, N.Panzavecchia, and G.Tine, "A new solution for low-voltage distributed generation interface protection system.,"IEEE Transactions on Instrumentation and Measurement, vol. 64, pp. 2086-2095, 2015. https://doi.org/10.1109/TIM.2015.2421691
B. F. Adiego, D. Darvas, E. B.Viñuela, J. C. Tournier, and S.Bliudze, "Applying model checking to industrial-sized PLC programs.," IEEE Transactions on Industrial Informatics, vol. 11, pp. 1400-1410, 2015. https://doi.org/10.1109/TII.2015.2489184
J.Han, C. S.Choi, W. K. Park, I. Lee, and S. H.Kim, "Smart home energy management system including renewable energy based on ZigBee and PLC,"IEEE Transactions on Consumer Electronics, vol. 60, pp. 198-202, 2014. https://doi.org/10.1109/TCE.2014.6851994
F. J.Sanchez-Pacheco, P. J.Sotorrío-Ruiz, J. R.Heredia-Larrubia, F.Pérez-Hidalgo, and M. S. D. Cardona, "PLC-based PV plants smart monitoring system: field measurements and uncertainty estimation.," IEEE Transactions on instrumentation and measurement, vol. 63, pp. 2215-2222, 2014. https://doi.org/10.1109/TIM.2014.2308972
R.N.Duche and N.P.Swarwade, "Sensor Node Failure Detection Based on Round Trip Delay and Paths in WSNs," IEEE Sensors Journal, vol. 14, pp. 455-465,2013. https://doi.org/10.1109/JSEN.2013.2284796
R. Eke, A. S. Kavasoglu, and N. Kavasoglu, "Design and implementation of a low-cost multi-channel temperature measurement system for photovoltaic modules," Journal of Instrumentation, vol. 45, pp. 1499-1509, 2012. http://dx.doi.org/10.1016/j.measurement.2012.02.029
H.Carlsson, B.Svensson, F.Danielsson, and B.Lennartson, "Methods for reliable simulation-based PLC code verification," IEEE Transactions on Industrial Informatics, vol. 8, pp. 267-278, 2012. https://doi.org/10.1109/TII.2011.2182653
Z. Aydogmus and O. Aydogmus, "A web-based remote access laboratory using SCADA,"IEEE Transactions on education, vol. 52, pp. 126-132, 2009. https://doi.org/10.1109/TE.2008.921445
B. Parashar and G. Taneja, "Reliability and Profit Evaluation of a PLC Hot Standby System Based on a Master-Slave Concept and Two Types of Repair Facilities,"IEEE Transactions On Reliability, vol. 56, pp. 534-539, 2007. https://doi.org/10.1109/TR.2007.903151
M.Ioannides, "Design and implementation of PLC-based monitoring control system for induction motor," IEEE transactions on energy conversion, vol. 19, pp. 469-476, 2004. https://doi.org/10.1109/TEC.2003.822303
D. W.Vernooy, J. S.Paslaski, H. A.Blauvelt, R. B. Lee, and K. J.Vahala, "Alignment-insensitive coupling for PLC-based surface mount photonics,"IEEE Photonics Technology Letters, vol.16, pp. 269-271, 2004. https://doi.org/10.1109/LPT.2003.819392
S. I. Naz, J. A. Hussain, B. A. Hafeez, and S. A. Naz., "Tokenization of sindhi text on information retrieval tool" PJEST, vol. 1, pp. 1-7, 2021. http://doi.org/10.5281/zenodo.4774104
K. A. Majeed, Z.Abbas, M. Bakhtyar, Z.Durrani, J. Baber, and I. Ullah, "Face Detectors Evaluation to Select the Fastest among DLIB, HAAR Cascade, and MTCNN," Pakistan Journal of Emerging Science andTechnologies,vol. 2, pp. 1-13, 2021. http://doi.org/10.5281/zenodo.5089391.[29]A. A. Noor, M.Bakhtyar, B. A.Chandio, R. Gull, and J. Baber, "Automatic cv ranking using document vector and word embedding" Pakistan Journal of Emerging Science and Technologies, vol. 2, pp. 1-9, 2021.http://doi.org/10.5281/zenodo.5089434